#Genogram definition software

You can create and position labels describing each tag using the same procedure used to create the main label.You fine tune the location by dragging and dropping the figure as described in the instructions for moving the label in 1.c.

The figure will remain outlined in gray but when you click away from the figure it will disappear. To make the figure invisible, be sure the figure is highlighted on your white space and click the same figure in the property pad.To create the tag, be sure the figure is highlighted then click on the desired tag in the property pad.Create a figure and place it adjacent to where you would like the tag to appear in the legend.

To do this you must create a figure to which the tag is attached and then make the figure invisible. You will want to create a tag, such as the one representing alcohol use, but without a visible connected figure.

#Genogram definition software

This is a typical drag and drop action used with many software products. When the label is positioned in the desired location release the left click button. Move the label to the desired location by depressing and holding down the left click button on your mouse and moving your cursor.Position your cursor in the white space and type.Click on the label “A” button located in the main tool pad in the left margin of the screen.You may want to begin by creating a main label that says “Key” or “Legend”. From this drop-down menu select “Tiny”, “Small”, “Standard” or “Large” depending on the figure size desired.Another drop down menu will appear when the cursor is placed over this phrase. Place your cursor over the phrase “Figure Size” in the drop-down menu. Click on the word “Pen” at the top left of the screen above the icons.Select the figure(s) you would like to increase or decrease in size.You can vary the size of one or more figures within the genogram using the Pen Menu. Select either “Zoom In”, “Normal Size” or “Zoom Out” to achieve the size adjustment desired. Click on the word “View” at the top left of the screen above the icons. You can make the genogram larger or smaller using the View menu.This is covered in Lesson 4 of the Tutorial within the software. The Zoom buttons are located in the margin above the workspace and appear as magnifying glass icons. You can make the genogram larger or smaller by clicking he Zoom buttons.You can vary the size of the entire genogram in two ways: